Dear PEI Member:
The Petroleum Equipment Institute has published a new document
entitled Recommended Practices for the Testing and Verification of Spill,
Overfill, Leak Detection and Secondary Containment Equipment at UST
Facilities (PEI/RP1200-12).
Spill, overfill, leak detection and secondary containment equipment has
been used at underground storage tank (UST) facilities for well over two
decades. Back in 2010, the PEI Board of Directors recognized that this
equipment must be maintained, inspected and tested on an
ongoing basis to be operated effectively and safely. The board asked 2010
PEI President Peter Ward to appoint a committee to write a document to
provide the industry with general guidelines for the verification and testing
of this equipment. The committee later expanded the scope of the document to
include the inspection and testing of shear valves and emergency stops.
In November 2011, EPA proposed new UST rules
requiring that spill, overfill prevention, secondary containment and leak
detection equipment be maintained and periodically tested to ensure
integrity and adequate performance over the life of these systems. To test
this equipment, EPA proposed that owners and operators of UST systems use
manufacturer's requirements or a code of practice developed by a nationally
recognized association or independent testing laboratory. EPA is currently
reviewing PEI/RP1200 and will decide whether to include it in its final UST
regulation, expected to be released sometime next year.
The document was written by the PEI Overfill, Release Detection and
Release Prevention Equipment Testing Committee: Edward S. Kubinsky, Jr.
(chair), CROMPCO, LLC; Scott C. Boorse, Wawa Inc.; Danny Brevard, AC'CENT
Environmental Services Inc.; Jim Brown, Belshire Environmental Services,
Inc.; Brian Derge, Tanknology; Lorri Grainawi, Steel Tank Institute; Brian
Harmon, Tait Environmental Services, Inc.; Kevin Henderson, Kevin Henderson
Consulting LLC; Jim Howard, Hess Corporation; Ron Kingsbury, UST Services
Corporation; Paul Miller, U.S. EPA OUST; and Steve Purpora, Purpora
Engineering, Inc. Don Gilson of Gilson Environmental served as consultant to
the committee.
If you test or inspect this equipment, you should have a copy of this
document. We urge you not to use the draft submitted to the industry for
review since public
comments to that draft resulted in changes―in one way
or another―to nearly 70 percent of the sections that make up the
recommended practice. PEI/RP1200-12 is copyrighted and may not be
photocopied or otherwise reproduced. Order online ($40 for members; $95 for
nonmembers) at www.pei.org/rp1200.
Two additional points regarding this new document:
- A 70-question online test designed to evaluate knowledge gained from
this recommended practice is available at
www.pei.org/tests. If you have an
annual subscription to the complete set of online tests, your employees
can now take the PEI/RP1200 test at no additional charge. Individual tests are $25
each.
- Committee member Kevin Henderson will present sessions describing the
key takeaways from RP1200 on two occasions during the PEI convention in
Las Vegas: October 8 at 9:15 a.m. and October 9 at 10:15 a.m.
|
PEI's RP1200 Released
PEI Board Elections Completed
RP1400 Committee Members Named

Exhibitor booth space for the PEI Convention at the NACS Show
in Las Vegas is SOLD OUT!
Register now to save $100 per registrant and ensure that you don’t miss
this must-attend industry event. Click
here to learn more about exciting educational sessions and networking
events.
PEI and Industry News »


Respond to this Newsletter
by
e-mail to the editor, Robert Renkes at
rrenkes@pei.org
or
join the discussion in the
Petroleum Equipment Forum
to
unsubscribe or change preferences
see below.
 |
PEI ELECTIONS COMPLETED: MORGAN ELECTED
William C. Morgan, Collins Equipment Corp., Cleveland, Ohio, has won the
runoff election in PEI District 4. He will succeed Timothy Woofter, Stanwade
Metal Products, Inc., Hartford, Ohio. Morgan will join six other directors
elected last month and eight incumbent directors on the 2012-2013 PEI Board
of Directors. The seven newly elected directors will be installed October 9
as members of the PEI Board during the association's annual membership
meeting and breakfast at PEI's convention in Las Vegas.
PEI RECOMMENDED PRACTICE COMMITTEE ON EMERGENCY GENERATORS NAMED
PEI President Joey Cheek has appointed a committee to write a
Recommended Practices for the Installation of Emergency Generator
and Fuel Oil Supplied Boiler Systems (PEI/RP1400). Members of the committee include:
- Roy Creley, Lakes Region Environmental Contractors (chair)
- Charlie Allsopp, First Petroleum Services, Inc.
- David Chrien, Service Station Equipment Co.
- John V. Cignatta, Datanet Engineering, Inc.
- Chris Collura, JMP Solutions
- Bill Duree, SunWest Engineering Constructors, Inc.
- Les Gray, Les Gray & Company, Inc.
- Arthur Hoffmann, A H Hoffman, LLC
- Steve Latimer, Mascott Equipment Company Inc.
- JD Martin, Southern Integrated Services, Inc.
- Darren Painter, Oscar W. Larson Co.
- Billy Pierce, Vital Fuel Systems
- Marshall Ryan, Unified Services of Texas, Inc.
- Tom Wyper, Wayne Perry, Inc.
EPA'S CONCERN RE: RESIDUAL FUEL IN BLENDER PUMP HOSE
The E15 Misfueling Mitigation Plans (MMPs) that EPA has recently approved (see
June 21, 2012 TL) include several requirements meant to address concerns
from motorcyclists and all-terrain vehicle users. These vehicle owners may
inadvertently misfuel due to residual E15 left in a blender pump hose used to
dispense both E15 and a gasoline-ethanol blended fuel containing no more
than E10. Byron Bunker, Acting Director of EPA's Compliance Division,
provided this explanation to the American Motorcyclist Association in an
August 1 letter: "EPA requires that retail stations that own or operate
blender pumps either dispense E15 from a dedicated hose and nozzle if able
or, in the case of E15 and E10 being dispensed from the same hose, require
that at least four gallons of fuel be purchased to prevent vehicles and
engines with smaller fuel tanks from being exposed to gasoline-ethanol
blended fuels containing greater than 10 vol% ethanol. Additionally, EPA is
requiring that retail stations that offer E10 and E15 from the same hose and
nozzle use additional labeling to inform consumers about the minimum
purchase requirement."
ETHANOL AND BIODIESEL
A U.S. federal appeals court has rejected an industry complaint filed by
trade associations representing automakers, refiners and other industries that
disputed an EPA decision allowing the optional sale of gasoline containing
15 percent ethanol for passenger vehicles built in the last decade. The suit
was dismissed because those bringing the action did not have legal standing
since they did not prove that E15 would cause injury or immediate harm to
their operations.
The director general for the UN's Food and Agriculture Organization
suggested that a temporary halt to the 10 percent blending of ethanol with
gasoline may be needed because of the severe drought, which has hit the corn
harvest and pushed up food prices. "The worst drought for 50 years is
inflicting huge damage on the US maize crop, with serious consequences for
the overall international food supply," wrote Jose Graziano de Silva in an
op-ed piece in the Financial Times earlier this month.
Argentina
ordered a tax hike on biodiesel exports―from
20 percent to 32 percent―effective August 11. The move
was intended to make domestic fuel prices more affordable. The country is the
world's biggest exporter of biodiesel.
Citing the severe drought in the U.S. this summer, four state
governors (North Carolina, Arkansas, Maryland and Delaware) have asked EPA
to temporarily waive the renewable fuel rule requiring ethanol to be blended
with gasoline. Several state governors made a similar appeal during a
drought in 2008 that EPA rejected.
STATIONS BOUGHT/SOLD
Tesoro has signed an agreement with BP to purchase the
company's Carson, California, refinery and about 800 ARCO-branded
dealer-operated retail stations in Southern California, Nevada and Arizona.
The deal includes about 60 company-owned, dealer-operated sites, which
Tesoro intends to sell post-closing.
7-Eleven, Inc. is selling 30 of the gasoline stations and convenience
stores in upstate and western New York that it acquired from the Wilson
Farms chain in 2011. Six of the sites are convenience stores only (no fuel)
and 24 are c-stores with gasoline.
Alimentation Couche-Tard Inc., through its indirect wholly owned
subsidiary, Circle K Stores Inc., has agreed to purchase 29 convenience
stores in Orlando, Florida, from Florida Oil Holdings LLC.
7-Eleven Inc. has signed an agreement with TETCO Inc. to
acquire the retail and wholesale assets of the San Antonio-based company.
The assets include about 200 company-operated convenience stores in Utah and
the Dallas-Fort Worth, Austin and San Antonio areas of Texas, plus fuel
distribution to TETCO's wholesale distributors. 7-Eleven plans to remodel
and rebrand most of the stores.
PENNSYLVANIA WON'T ENFORCE STAGE II REQUIREMENT FOR NEW STATIONS
The Pennsylvania Department of Environmental Protection (DEP) will not
require that Stage II vapor recovery systems be installed in new gasoline
stations in southeast and southwest Pennsylvania, according to an
August 15 announcement. The announcement does not affect stations currently
with Stage II systems. "These so-called Stage II vapor recovery systems must
still be operated and maintained at existing facilities until further
notice," DEP Secretary Mike Krancer said. "We will, however, use our
discretion to not enforce these requirements for any new gas station in the
greater Pittsburgh and Philadelphia areas because the diminishing benefits
do not justify the cost of installing new systems." Stage II vapor recovery
systems are required for about 1,600 gasoline dispensing facilities in
Allegheny, Armstrong, Beaver, Bucks, Butler, Chester, Delaware, Fayette,
Montgomery, Philadelphia, Washington and Westmoreland counties.
MEMBERSHIP APPLICATIONS
Louisiana distributor. STT Services, LLC, P. O. Box 278, Breaux Bridge,
Louisiana 70517, has applied for distributor division membership. Charlene
Indest Guidry is CEO of the company, which was established in 2010. STT
Services installs and services equipment and represents Ameron,
CentralIL, EmcoWheatn, Flex-Ing, GPI, LSI, Newberry, PtrCntmt, RDMElec,
Vaporless, VeriFone and Wayne. Sponsored for PEI membership by Russ Lange,
GPI, Wichita, KS.
South Carolina distributor. Quality Air Tool, Inc., 1910-A North Cashua
Drive, Florence, South Carolina 29501, has applied for distributor division
membership. Shawn Hilley is general manager for the firm, which was
established in 1978. The company represents Balcrank, Catlow, ChampLabs,
GPI, HuskyCorp, Morrison, RobertShaw and Tuthill. Quality Air Tool sells,
installs and services aboveground tanks, petroleum and lubrication
equipment, air compressors, lifts and car wash equipment. Sponsored for PEI
membership by Kelly A. Mulligan, Morrison, Dubuque, IA.
www.teamqat.com
Cleaning card manufacturer. CleanTech Company, 3400 SW 26th Terrace,
Building A9, Dania Beach, Florida 33312, has applied for affiliate division
membership. Stan Eyler is president of the firm, which was established in
2011. The company manufactures cleaning cards for credit card readers,
thermal printers and currency validators. Sponsored for PEI membership by
Bob Chase, Bennett, Spring Lake, MI.
www.cleantechcorp.com
Egypt import/export firm. Egyptian Company for Import & Export, 8 Al
Amal Street, Aghakhan, Shoubra, Cairo, Egypt 11241, has applied for
affiliate division membership. Maged Maher Ghattas is general manager of the
firm, which was established in 2002. The company imports and exports
petroleum piping. Sponsored for PEI membership by Staffan Helleday, KPS,
Kungsor, Sweden.
New Jersey engineering firm. Oxford Engineering Company, 336 Point
Street, Camden, New Jersey 08102, has applied for service and construction
division membership. Julian T. Canuso, Jr., is president of the firm, which
was established in 1991. The company offers consulting and construction
services. Sponsored for PEI membership by Frank B. Evans, CoreEng, Herndon,
VA. www.oxfordengineering.com
ADMITTED TO PEI
- GEMRIKUSA, LLC, Fort Worth, TX (mfr)
- Zyntech Systems, Ltd., Raleigh, NC (mfr)
- M. Carder Industries, Inc., Fenton, MO (mfr)
- Grana Industria Publicitaria, Santa Fe, Argentina (aff)
- MBM Engineering, Belo Horizonte, Minas Gerais, Brazil (aff)
- BLJC, North York, Ontario, Canada (aff)
- Fluid Control Systems, Inc., Jeffersonville, IN (S&C)
- Joe Coulee Enterprises, Ltd., Blair, WI (S&C)
- Steve Albers, BP Products North America Inc., Oviedo, FL (O&E)
- Robert T. Bond, Sr., U.S. Navy, Meridian, MS (O&E)
- Perry Dodge, Hess Corporation, Woodbridge, NJ (O&E)
- Terrell Fields, Alabama Power Co., Birmingham, AL (O&E)
- Tim Harbison, Alabama Power Co., Birmingham, AL (O&E)
- David Sims, Alabama Power Co., Birmingham, AL (O&E)
|